Troubleshooting; Technical Specification - Tesla BG300G User Manual

Exhaust filter
1. The exhaust filter (C) is located under the ventilation grille (5).
2. Push the release lever upwards to remove the ventilation grille.
Refer to Fig.8
3. Remove the exhaust filter and wash it in clear warm water.
Do not add any cleaning agents as they damage the filter.
4. After washing, dry the exhaust filter completely. If necessary, let
it dry in the air.
5. Place the exhaust filter back to its original position.
6. Attach the ventilation grille and lock it.
Storage
1. Let the appliance completely cool down before storing.
2. Rewind the power cord completely.
3. Position the appliance either vertically (Fig. 9) or horizontally
(Fig. 10) in order to suspend the storage hook (16) on the
combination nozzle (19) in the storage assistance holder on
the rear or the bottom of the appliance.
4. Store the appliance in a dry and cool place protected from
direct sunlight and out of reach of children.

TROUBLESHOOTING

Problem
Poor suction power
Vacuum cleaner does not switch ON
Power cord will not rewind

TECHNICAL SPECIFICATION

Voltage: AC 220V-240V~
Frequency: 50Hz-60Hz
Power: 800W
Correct Disposal of this product:
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact
the retailer where the product was purchased, they can take this product for environmental safe recycling.
Possible cause and solutions
• Dust bag full - replace dust bag
• Tube or hose blocked-remove blockage from tube or hose
• Filters dirty - clean filters
• Power cord not connected - connect to mains supply. If problem still persists
contact a qualified technician.
• Power cord extended beyond yellow marking - press the cable rewind button
again and carefully pull the cord. If this does not help, have the appliance
checked by a qualified electrician.
Fig. 8
Fig. 9
Fig. 10
7