Operation - Tesla BG300G User Manual

ASSEMBLY
1. Insert the suction hose adaptor (28) into the suction
hose inlet (26) until it locks in place. While connecting
press the suction hose release buttons (27) on the
suction hose adaptor. To remove the suction hose,
press the suction hose release buttons and pull out the
suction hose.
2. Attach the telescopic suction tube (14) to the end of
the handle (12) until it is firmly connected.

OPERATION

General use
1. Pull out the power cord (2) to the required length. Do
not pull further than the yellow marking on the power
cord to avoid damage.
2. Insert the power plug into a suitable mains supply
socket.
3. Choose the correct setting for the floor by pressing the
brush in or brush out switch (18).
Brush out: wooden floors, titles, marble
Brush in: carpets/textile surfaces
4. Turn on the appliance by pressing the ON/OFF
switch (7).
5. Adjust the suction power by turning the suction power
control button (8).
Suction power control settings
Turning the suction power control button (8) clockwise to increase power and
turning anticlockwise to decrease the power (Fig.1).
Please refer to the following recommended power settings:
MIN: for curtains and delicate fabrics
Medium: for high-pile carpets and textile flooring
MAX: for sturdy rugs and floors
Air flow regulator
Open the air flow regulator (13) on the handle (12) in order to regulate the air
flow or to clear the objects blocking the nozzle (Fig.2). Gradually open the air flow
regulator to decrease the suction power.
Nozzle attachments
Combination floor nozzle
The combination floor nozzle (19) has two settings: brush out and brush in. Press
the brush out switch at the combination nozzle in order to switch the brush out
(Fig.3). Press the brush in switch to retract the brush.
Brush out: wooden floors, titles, marble
Brush in: carpets/textile surfaces
3. Extend the telescopic suction tube by pushing the tube
release slide (15) downwards. Release the tube release
slide as soon as the required length of tube has been
reached. Make sure it locks into position.
4. Attach the combination nozzle (19) or the 2 in 1
crevice/brush nozzle (20) or the upholstery tool (22) to
the end of the telescopic suction tube.
Also see section "Suction power control settings".
6. Vacuum clean at a steady speed. The wheels (1) will
support an easy movement of the appliance.
7. After use press the ON/OFF switch to switch the unit
OFF.
8. Disconnect the plug from the mains socket.
9. Hold the plug securely in order to guide the power cord
while pressing the cable rewind button (4).
10. Pay attention to the range that can be covered with the
cable length.
11. Always disconnect the power plug from the mains
socket before rewinding the cable.
Fig. 1
Fig. 2
Fig. 3
5