Adjustments; Lid Adjustment - Ametek mocon Dansensor LeakPointer H2O User Manual

24 User Guide

Adjustments

Lid adjustment

If the lid does not seal properly and evenly against the tub sealing, this can be adjusted:
NOTE! This requires that the sealing is correctly mounted on the tub - see
"Replacement of parts" on page
1. Loosen the 4 screws
2. Close the lid
adjust vacuum to approx. 100 mbar.
3. When you feel the lid being sucked close to the tub, verify that the lid seals evenly against
the tub sealing, then tighten the 4 screws
4. Release the vacuum then start test again to check that lid seals properly now.
P/N 390225-C
11/2021
26.

(2 on each side) connecting the lid

and while slightly pressing it downwards, start the vacuum ejector and
EN Dansensor

to the console

again.
LeakPointer H O
®
2

.