Table of Contents
Advertisement
28
User Guide
Replacing the silencer
Required tools:
Screwdriver, Torx 10
Wrench, 19 mm
1. Disconnect the compressed air supply hose
blue sleeve on the connector, then pull the hose out of the connector.
2. Remove the 6 screws
3. Tilt the rear panel
4. Replace the silencer
5. Mount the rear panel
P/N 390225-C
11/2021
(Torx 10 screwdriver) holding the rear panel
out to access the silencer
.
CAUTION! The silencer is loosened and tightened by hand only - we recommend
holding against with a wrench (19 mm)
avoid damaging the existing assembly.
again and connect the compressed air supply hose
CAUTION! When mounting the real panel
coming from the compressed air supply fitting is not squeezed between the
panel
and the bracket
EN
Dansensor
. To disconnect the hose, push down on the
.
on the already mounted fitting to
, make sure the especially the hose
.
LeakPointer H
O
®
2
.
.
Advertisement
Table of Contents
