Table of Contents
Advertisement
Dansensor
LeakPointer H
®
Adjusting the tub positioning sleeves
NOTE! We recommend that two persons perform this operation, as it requires for
the unit to be tilted while screws are tightened underneath.
If the tank is slightly skewed or if it needs to be turned to change the location of the drain
outlet, it may be necessary to slightly adjust the tub positioning sleeves:
1. Drain the tub
2. Tilt the unit to be able to loosen the 4 screws
to the base
.
NOTE! The screws
little force to move the sleeves
3. Mount the tub
of the lid and the sealing
sleeves
.
4. When finished, while holding the lid closed to keep the tub in place, tilt the device
backwards to be able to tighten the 4 screws
O
EN
2
and lift it off.
should only be loosened so much that it still requires a
in the sleeves
again and then close the lid
. If necessary wiggle the tub
(underneath) that secure the sleeves
.
to adjust the positions of the
.
User Guide
to check the alignment
P/N 390225-C
11/2021
25
Advertisement
Table of Contents
Need help?
Do you have a question about the mocon Dansensor LeakPointer H2O and is the answer not in the manual?
Questions and answers