Filling Of Water; General - Ametek mocon Dansensor LeakPointer H2O User Manual

12 User Guide

Filling of water

General

Water temperature should be max. 50°C.

Add 1-2 ml non-alkali detergent to the water, to conserve it and make it softer.

If local water is very calcareous, we recommend to use de-mineralised water.

NOTE! Frequent cleaning is recommended to avoid bad hygiene and complicated
cleaning - see
In general, it is always important to consider how much water should be in the tub

relation to the types of packages to be tested:
- If the purpose is to test relatively small packages, the tub should be filled so that the
surface is slightly above the underside of the hole-plate
25 liters - check scale
- If it is larger packages that can expand a lot during the test, the amount of water in the
tub must be adjusted so that the water level in the tub is somewhere between the
underside of the hole-plate
is fully expanded during the test.
There are two ways to fill the tub with water. It can be filled either manually (see

by using the vacuum function (see
P/N 390225-C
11/2021
EN
"5. Cleaning and maintenance" on page

).

and the "Max" marking on the scale
page 14).
Dansensor LeakPointer H
®
22.
 
when lid is closed (approx.

when the package
page
O
2

in
13) or