AMT Datasouth Fastmark M9 Plus User Manual page 51

Tear Off
Print mode
Print Width
List Fonts
List Images
List Formats
List Setup
Control Prefix
Format Prefix
Delimiter Char
Media Power Up
Head Close
Label Top
Left Position
Reprint Mode
This item is used to fine tune media stop location. Available
setting values range from -120~120 dots.
This item is used to set the print mode. There are 3 modes as
below,
Printer Mode Description
Next label top of form is aligned to the print
Tear Off
head burn line location.
Peeler Off Enable the label peel off mode.
Cutter Enable the label cutter mode
Rewind Enable the label rewind mode
This item is used to set print width. The available value range
is 2 ~ 999 dots.
This feature is used to print current printer available fonts list
on the media. The fonts are stored in the printer's DRAM,
Flash or optional memory card.
This feature is used to print current printer available images
list to the media. The images are stored in the printer's
DRAM, Flash or optional memory card.
This feature is used to print current printer available formats
list to the media. The formats are stored in the printer's
DRAM, Flash or optional memory card.
This feature is used to print current printer configuration to the
media.
This feature is used to set a control prefix character.
This feature is used to set a format prefix character.
This feature is used to set a delimiter character.
This option is used to set the action of the media when you
turn on the printer.
Selections Description
Feed
Printer will advance one label
Printer will calibrate the sensor levels,
Calibration
determine length and feed label
Length Printer determines length and feeds label
No Motion Printer will not move media
This option is used to set the action of the media when you
close the printhead.
Selections Description
Feed
Printer will advance one label
Printer will calibrate the sensor levels,
Calibration
determine length and feed label
Length Printer determines length and feeds label
No Motion Printer will not move media
This option is used to adjust the print position vertically on
the label. The range is -120 to +120 dots.
This option is used to adjust the print position horizontally on
the label. The range is -9999 to +9999 dots.
When reprint mode is enabled, you can reprint the last label
printed by pressing the
panel.
button on the printer's control
- 42 -
0 dot
Tear Off
812
N/A
N/A
N/A
N/A
N/A
N/A
N/A
No Motion
No Motion
0
0
Disabled