AMT Datasouth Fastmark M9 Plus User Manual page 32

3.4.3 Loading Media in Peel-off Mode (Option)
Label
Liner
1. Open the printer right side cover.
2. Please refer to section 3.4.1 for loading
media.
3. Using the front display panel to do the
calibration first and set the printer mode to
peeler mode.
Note:
1. Please calibrate the gap/black mark
sensor before loading media in the
peel-off mode to avoid a paper jam.
2. Please feed the label through media
guide bar as picture shows.
4. Open printhead release lever, pull
approximately 650 mm of the label through
the front of the printer.
5. Remove several labels to leave liner.
- 23 -