AMT Datasouth Fastmark M9 Plus User Manual page 49

The direction setting value is either 1 or 0. Use this item to setup
the printout direction.
Direction
This item is used to set the print mode. There are 6 modes as
below,
Print mode
This item is used to fine tune media stop location. Available
Offset
setting range values are from -999 dots to 999 dots.
Shift X
This item is used to fine tune print position. Available setting
Shift Y range values are from -999 dots to 999 dots.
Reference X
This item is used to set the origin of the printers' coordinate
system horizontally and vertically. Available settings range
Reference Y
from 0 dot to 999 dots.
Code page
Use this item to set the code page for international character set.
Use this option to set the country code. Available setting
Country
values range from 1 to 358.
Note: If printing from a driver, the driver will send out the commands, which will
overwrite the settings made from the printer panel.
DIRECTION 0
Printer Mode Description
None
Next label top of form is aligned with the print head
burn line location. (Tear Off Mode)
Batch Mode Once image is printed completely, label gap/black
mark will be fed to the tear plate location for tear off.
Peeler Mode Enable the label peel off mode.
Cutter Mode Enable the label cutter mode.
Cutter Batch Cut the label once at the end of the printing job.
Rewinder Enable the label rewinder mode.
Mode
DIRECTION 1
- 40 -
0
Batch
Mode
0 dot
0 dot
0 dot
0 dot
0 dot
850
001