Initial System Setup; Connection To Das System; Software Upgrade; Full System Software Upgrade - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000

Initial System Setup

User Manual
10 Initial System Setup
This chapter provides the basic configuration setup items to get a system up and running.
system, see "SNMP".
Note: If you wish to setup SNMP during the initial setup of the

10.1 Connection to DAS System

The entire DAS system is setup and configured via the Configuration GUI on the Primary Hub.
Access the GUI on your Primary Hub using a Web Browser, as described in the previous section.

10.2 Software Upgrade

Equipment is shipped with the latest version of software at the time of manufacture. However, updates
may have been made after shipping. The latest version of software is always available via your Zinwave
supplier or from the support area on our website https://portal.zinwave.com/portal-gateway/
(Registration is required). A UNItivity 5000 software update will update the Primary Hub software, as
well as firmware on connected Secondary Hubs and Remote Units. Complete this step first if newer
software is available.
10.2.1

Full System Software Upgrade

The Software Upgrade feature allows the user to deploy a software update to the Primary Hub and all
attached Secondary Hubs and Remote Units in a DAS, using a single upgrade file.
The Units table in the Software Upgrade page shows all the hardware elements present in the system,
including their Labels and Hardware and Software versions. Ensure that the system is complete and
stable prior to starting an upgrade. All Secondary Hubs and Remote Units in the system should be
updated to the firmware versions contained in the software release image that is deployed to the
Primary Hub.
Copyright © 2022 Zinwave. All rights reserved. 10-1