Understanding The Configuration Gui; Supported Browsers; Initial Standalone Access - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000

Understanding the Configuration GUI

User Manual
9 Understanding the Configuration GUI
A Configuration Graphical User Interface (GUI) is available to configure your equipment locally or
remotely via ethernet. The GUI is hosted on the Primary Hub and is used to configure and monitor the
Primary Hub and all connected Secondary Hubs and Remote Units. This section describes how to
access the GUI and the general features of this interface. Specific configuration items are located in
their respective sections.
Windows may appear slightly different based on your browser; however, all features are the same. The
screen shots shown in this document are from Google Chrome.
Each main GUI page is selected via the items in the left navigation menu. Comprehensive help is easily
accessible in the GUI by clicking on the arrow tab on the right side as circled in red below. Help for
System Views in the bottom left of the screen is provided within the help for the System Status GUI
page.

9.1 Supported Browsers

The Configuration GUI is a web-based application. It runs on a variety of browsers including: Windows
Edge and Internet Explorer, Mozilla Firefox, Google Chrome, and Safari.

9.2 Initial Standalone Access

Every hub is set to the same IP address (192.168.0.2) on leaving the factory, and after performing
factory preset. In order to access the GUI in this state, the simplest method is to use a direct ethernet
connection from a standalone PC. To do this, you need to match the PC's IP address to the same
subnet as the default Primary Hub address.
Copyright © 2022 Zinwave. All rights reserved. 9-2