Innovation, Science And Economic Development Canada Compliance Statement; Ce Information - ZinWave UNITIVITY 5000 User Manual

harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Note: This is Class A product (as defined in European Norm (EN) 55032). In a domestic environment
this product may cause radio interference.
Innovation, Science and Economic Development
Canada Compliance Statement
The nominal passband gain of 305-0XXX system is 25 dB and the 20dB bandwidth is 125 MHz to 3.14
GHz. The input and output impedances are 50 ohms and the RSS-131 rated mean output power P
is:
•
+15 dBm in 150-174 MHz band
•
+19 dBm in the 406.1 – 430 and 456 – 470 MHz bands
•
+20 dBm in all other bands
The system must be configured with maximum transmit power of +16 dBm in the 2345-2360 MHz band.
The nominal passband gain of 305-XXXX system through a 305-1007 Remote Unit is 29 dB and the
24dB bandwidth is 125 MHz to 3.14 GHz. The input and output impedances are 50 ohms and the RSS-
131 rated mean output power P
•
+15 dBm in 150-174 MHz band
•
+19 dBm in the 406.1 – 430 and 456 – 470 MHz bands
•
+20 dBm in all other bands below 1575 MHz
•
+24 dBm in all other bands above 1575 MHz
The system must be configured with maximum transmit power of +16 dBm in the 2345-2360 MHz
The nominal passband gain of 306-XXXX system is 29 dB and the 24dB bandwidth is 3150 MHz to
4350 MHz. The input and output impedances are 50 ohms and the RSS-131 rated mean output power
P is:
RATED
•
+24 dBm in 3300 - 4200 MHz band
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations
when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially
where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of
the device.

CE Information

UNItivity complies with the essential requirements of the Radio Equipment Directive
(2014/53/EU) and is therefore 'CE' marked when it is used in accordance with the instructions
provided in this Manual.
CE Declaration of Conformity
This equipment has been tested and found to comply with the limits set out by the Directive 2014/53/
Copyright © 2022 Zinwave. All rights reserved.
is:
RATED
RATED
xvi