Hub And Module Leds; Primary Hub Front Panel Leds; Secondary Hub Status Leds; Optical Link To Primary Hub - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000
User Manual

3 Hub and Module LEDs

3.1 Primary Hub Front Panel LEDs

There are four LEDs on the front of the Primary Hub. The following table describes them:
Symbol Name
Power Indicator
Service Indications
Warning Indicator
CPU Indicator

3.2 Secondary Hub Status LEDs

3.2.1 Optical Link to Primary Hub

LED Color
Off
Red
Alternate
Red/ Green
Green
Flash
Green
Copyright © 2022 Zinwave. All rights reserved.
Status Color Description
Green Power connected to CPU
board
Off No power connected
Green No error. System is fully
functional
Red Loss of service currently
active
Red/Green Firmware programming in
Flashing progress
Green All Units operating
correctly
Orange Service or Hardware
warning currently active
Green CPU running
Orange CPU restarting
Description
Secondary Hub not powered.
Secondary Hub that had been in fully operational state has
lost communication/association with Primary Hub.
Secondary Hub waiting to be associated with Primary Hub
following power-on/reboot.
Secondary Hub successfully associated with PH, but there are
no fully operational Remote Units attached.
Secondary Hub successfully associated with Hub, and there is
at least 1 fully operational Remote Unit attached.
Hub and Module LEDs
Comment
Shows processor is correctly
powered
This alarm cannot be masked
and will ALWAYS be Red when
loss of service conditions active.
Shows Processor is correctly
operational
3-10