ZinWave UNITIVITY 5000 User Manual page 55

UNItivity 5000
User Manual
1)
3. Remove the bracket.
4. Drill the 4 screw holes.
5. Attach the bracket to the wall using the a M4 screw driver and the 4x M4 screws.
6. You may need to use additional hardware such as raw plugs, for a secure fit.
7. Ensure the 4 M3 locking bolts are in place on the wall bracket, but not screwed in so far as to
protrude into the inner cavity of the wall bracket and prevent the mounting bracket on the
Remote Unit from being inserted.
8. Align the plastic mounting bracket attached to the back of the Remote Unit with the wall
bracket, and 'plug in' the Remote Unit. The plastic latches should clip in and hold the
Remote Unit in place. If the Remote Unit needs to be removed, then hold the Remote Unit
on both sides with fingers reaching behind to press the central release buttons on the
mounting bracket, allowing the Remote Unit to be 'unplugged'.
Copyright © 2022 Zinwave. All rights reserved.
Installing Remote Units
6-3