Accessing The Gui - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000
User Manual

9.3 Accessing the GUI

The GUI is initially accessible via a
changed to an unsecured (http) connection via the
page.) For initial configuration of a device, you need local access via an ethernet connection to the front
of the Primary Hub. After that, you can access the Hubs and Remote Units remotely on the network
you created during the initial setup.
To access the GUI:
1. Open the desired browser.
2. In the address line, enter
Primary Hub you wish to configure. For an initial configuration the IP address is
https://192.168.0.2. If
that address.
3. Press Enter.
4. A Security Certificate authorization may appear depending on whether the PC you are using
to access the device has previously been used. If it appears, continue to step 5. If not, and
the Login window appears. Go to step 7.
5. Accept the Security Certificate.
6. Depending on your browser, a series of acceptances may need to be confirmed. Click
through the options to accept the Certificate. You may need to select advanced options to
see all acceptance options.
7. The Login window appears (browser specific.)
8. Enter the username and password. There are three privilege levels available.
Copyright © 2022 Zinwave. All rights reserved.
Web browser through a secure (https) connection (but can be
"User Interface Settings"
"https://ip_address"
"IP Settings"
you changed it in the
Understanding the Configuration GUI
where the IP address is the address of the
section of the Hub Setup page, use
section of the Hub Setup
9-4