Performing A Basic Installation - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000
User Manual

4 Performing a Basic Installation

The following procedure is intended to provide you with a basic work flow to get a new system up and
running. It provides references to specific instruction for that step.
To install UNItivity 5000:
1) Unpack and verify all components (See section
2) Rack mount Hubs and populate with the appropriate modules (See section
Populating Hubs").
3) Install Remote Units and antennas (See section
Antennas to Remote
4) Install power for Remote Units (local or PSU) (See section
5) Make and check all connections for power and data between Primary, Secondary, and
Remote Units. This will be fiber for Optical Connections. (See section
6) Ground any Rack Mounted Equipment.
7) Power on all equipment.
8) Watch LEDs for self-test and connection. (See section
connections on infrastructure cables using LEDs (see
and check power as needed.
9) Connect the PC to the Primary Hub to configure system. (See section
Access").
10) Access the GUI and view status pages (See section
Primary Hub software is the latest version. Perform software upgrade if needed.
11) Set up the system based on the coverage tool and measured inputs. (See section
Setup").
Copyright © 2022 Zinwave. All rights reserved.
Units").
Performing a Basic Installation
"Installing and Populating Hubs"
"Installing Remote Units"
"Powering Remote
"Fiber Patch
"Start-up Sequence"). Trouble shoot
"Hub and Module
"Accessing the
).
"Installing and
"Connecting
and
Units").
Cords").
LEDs"). Swap fibers
"Initial Standalone
GUI") and ensure
"System
4-2