3000 Snmp Traps; Additional 5000 Snmp Objects - ZinWave UNITIVITY 5000 User Manual

In-building wireless solution
Table of Contents

Advertisement

UNItivity 5000
User Manual
13.4.4

3000 SNMP Traps

The following SNMP traps are supported:
Hub3000Notify.Hub3000Heartbeat – This is a heartbeat trap which is sent every 20 minutes
to the listening SNMP manager. It contains the following objects: Hub3000String,
Hub3000DeviceType, Hub3000ModelName, Hub3000FaultRelayState
Hub3000Notify.Hub3000FaultRelayStatus – This trap is sent each time a new alarm is raised
in the system, and when the fault relay is manually cleared from the PH GUI. It contains the
following objects: Hub3000String, Hub3000DeviceType, Hub3000ModelName,
Hub3000FaultDescription, Hub3000FaultRelayState
The IP address and port of the SNMP trap receiver (SNMP Manager), is set via the LAN Setup page
of the Hub graphical user interface.
Some notes on the SNMP interface and alarms:
During start-up alarms will be written to the event log, but the fault relay will not set, and no
trap will be sent. This start-up period lasts 5 minutes.
If any alarms remain or any units are still missing once start-up has completed, the Hub will
loop through the alarm conditions and send out traps.
13.4.5

Additional 5000 SNMP Objects

The
unitivity5000Module
ZINWAVE-MIB.
13.4.5.1 unitivity5000Notifications
This group supersedes both the Hub3000Events and the ext3000NotificationsGroup.
The unitivity5000Notifications group contains these notifications :
unitivity5000Heartbeat
unitivity5000FaultRelayStatus
unitivity5000DASoperationalStatusChange
unitivity5000ServiceLossOfServiceChange
unitivity5000RUconfigLossOfServiceChange
unitivity5000ModuleLossOfServiceChange
unitivity5000ModuleServiceWarningChange
unitivity5000ModuleHardwareWarningChange
unitivity5000NotificationsLost
unitivity5000RMPSUAlarmsChange
Which replace similar notifications in ZINWAVE-MIB and should be used in the same manner
Copyright © 2022 Zinwave. All rights reserved.
group contains notifications which augment the ext3000UnitConfigTable from
Understanding Alarms & Reporting
13-31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents