Transport Module - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000
User Manual

3.4.3 Transport Module

The following table shows a typical LED start up sequence for a fully enabled Transport Module plugged
into the front slot of a UniTransport Hub.
Left Middle
Off
Off
Off
Off
Green
Flash
Green
The following table shows a typical LED start up sequence for a fully enabled Transport Module plugged
into the rear slot of a Primary Hub.
Left Middle
Off
Off
Off
Off
Off
Copyright © 2022 Zinwave. All rights reserved.
Right
Off Dull
Red
Off Green
Red Green
Green Green
Green Green
Green Green
Right
Off Dull
Red
Off Green
Red Green
Red Green
Flash
Green Green
Status
Initial power-up. Power present on Hub allowing
Transport Module to be detected; or
Transport Module NOT Enabled through System Setup.
Transport Module successfully detected, starting
discovery of downstream Primary Hub.
Potential communication failure state: No incoming light
on fiber or no downstream system elements have
responded after several communication attempts
(discovery continues).
Communication success state: communication
established with a downstream Primary Hub.
Optical calibration and auto-setup of downstream units in
progress, and/or RF path to downstream Primary Hub is
disabled.
Transport Module is connected to active downstream
Primary Hub.
Status
Initial power-up. Power present on Hub allowing
Transport Module to be detected; or
Transport Module NOT Enabled through System Setup.
Transport Module successfully detected, starting
discovery of downstream Primary Hub.
Potential communication failure state: No incoming light
on fiber or no messages from upstream UniTransport
Hub.
Potential failure state: Hardware Warning Alarm is
present on this Transport Module.
Transport Module is connected to active upstream
UniTransport Hub.
Hub and Module LEDs
3-14