Installing And Populating Hubs; Installing The Hub; Mounting Kit - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000
User Manual

5 Installing and Populating Hubs

This chapter describes how to install insert modules into Primary and Secondary Hubs.

5.1 Installing the Hub

You can mount a Primary or Secondary Hub in a standard 19" (48.26cm) rack or an open frame rack.
There are many 19" rack systems available on the market of various depths. It is essential that the
weight of the Hub is supported at the front and back. If the Hub is not adequately supported in your
rack, you must provide support items, such as front-to-rear chassis runners (rails) or fully supported
shelves. This manual provides instructions to mount a Hub in a rack using the only items supplied in
the mounting kit.

5.1.1 Mounting Kit

Each Hub is delivered with an accessory box of parts used for rack mounting. This box contains the
following parts:
Part Number Qty
128-0118 8
142-0257-01 2
142-0048-05 12
128-0043 12
128-0113 4
128-0112 4
1
Copyright © 2022 Zinwave. All rights reserved.
Detail
Screw M4 X 10 CSK POZI
STL Black
Rack Mounting Bracket
5000 Hub Module Blank
Plate
Screw Thumb 6- 32X8mm
PC Case
M6 Cup Washer Black
Screw M6x12 PAN POZI
STL Black
Power Cord
Installing and Populating Hubs
Function
Mounting Bracket Screw
Mounting bracket for rack
Blanking plates for unused
slots
Retaining Screws
Mounting Bracket washers
Hub Mounting Screws
(suitable for M6 Cage nuts,
not supplied)
Country specific power cord
Image
5-1