Installing Blank Panels - ZinWave UNITIVITY 5000 User Manual

UNItivity 5000
User Manual
To install the Primary Hub in a rack:
16) Remove all parts from the Accessory Box included in the box with the Hub.
17) Attach the mounting brackets (using the black countersunk screws 128-0118) to the side of
the Hub in the correct position for the rack.
18) Place the Primary Hub into the rack and secure using suitable Hub mounting screws and
washers.

5.1.4 Installing Blank Panels

Blank panels are available to cover unused slots on a Primary Hub.
To install blank panels:
19) Place a blank panel over a slot that will not be used and align so that plate hole fits over
screw hole at bottom.
20) Slots are ordered in the back from A to D and in the front from 1 to 8. Place blank panels
on slots that are not needed. For example, if you are using slots 1 to 4, place blank plates
on slots 5 to 8.
21) Insert a retaining screw in the hole and turn to hand-tighten.
Copyright © 2022 Zinwave. All rights reserved.
Installing and Populating Hubs
5-3