Autosampler Use; Introduction; Autosampler Installation; Autosampler Set-Up - Thermo Scientific iCAP 7000 Series Manual

iCAP Customer Familiarisation Manual

6 Autosampler Use

6.1 Introduction

The autosampler can be configured to suit an application, or several applications.
The volume, number and type of sample will all influence the set-up of the autosampler and
instrument.

6.2 Autosampler Installation

To comply with safety and warranty requirements the iCAP 7000, accessories and associated
equipment must be installed by a Thermo Fisher trained and certified engineer.
Refer to the Autosamplers Operators Manual for assembly and maintenance.

6.3 Autosampler Set-up

For analysis with an autosampler the capillary tubing attached to the end of the autosampler
probe should be attached to the end of the sample pump tubing on the iCAP 7000. To minimise
the sample volume required the length of the capillary tubing should be minimised, but should
allow free movement over the whole sample area of the autosampler.
This document is part numbered 849940090071 Version 1.02
Page 21 of 72