Alpha ESS SMILE-T10-HV Installation Manual page 14

MOUNTING
4. After cleaning the dust and other objects from the two holes, place 2 wall anchors into
the holes, then attach the battery wall bracket to the wall by using the SW10 hexagon
sleeve.
5. Install the cardboard limit board on the battery pack with screw M5*12 (X 2) (tool: T20
screwdriver, torque: 2.5Nm).
22 23
6.
Place the battery against the wall, align the holes at the battery side to the screw holes
of the wall bracket.
7. Tighten the wall bracket and the battery pack with screw M5*12 (X 2) (tool: T20
screwdriver, torque: 2.5Nm)
If the floor of installation site is uneven, please use floor gaskets to level at the bottom
of the battery pack.
WARNING
Risk of injury when lifting the battery pack, or if it is dropped
The Battery Pack is very heavy weighs ≥ 72 kg. There is risk of injury if the battery pack is lifted
incorrectly or dropped while being transported or when attaching it to or removing it from the
wall bracket.
Transport the battery pack always as described below.
It is forbidden to stack 3 batteries from top to bottom.
8.
Mounting more batteries
You can install extra batteries up to 6 batteries in a system.
Please install extra batteries by side , also batteries can be stacked up to two batteries
per column. Expansion wiring please refer to Chapter 7.9 .
1) If you will install extra batteries by side , please repeat steps 1-6 and keep the distance
between two batteries greater than 300mm. The space between the left and the right
battery is a recommended distance. Keep the distance as short as you can if there is no
influence to the operation.
1
2
MOUNTING
6