Creating A Program; General Configuration Of Program - Mitsubishi Electric MELSECQ Series User Manual

7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL

7.3 Creating a program

7.3.1 General configuration of program

7 - 5
Downloaded from ManualsNet.com
This section explains "positioning control operation programs" actually used. The
programs designed to perform the functions described in "SECTION 2 CONTROL
DETAILS AND SETTING" are installed in the "positioning control operation programs"
explained in "Section 7.3.2". (To monitor control, add a necessary monitor program
according to the system. Refer to "Section 4.6 List of monitor data" for monitor items.)
The general configuration of the "positioning control operation program" is shown
below.
Start of program creation
Set using the
GX Configurator-PT
Initialization program
Start method setting program
JOG operation program
Completion of program
search engine
Set using the
sequence program
Parameter and
data are...
Parameter and data
setting program
Refer to section 7.5.1
Refer to section 7.5.2
Start program Refer to section 7.5.3
Refer to section 5.7
Sub program Refer to section 7.5.4
Stop program
creation
MELSEC-Q
7 - 5