Elvis Function Generator Configuration Switch (Sw8); Elvis Voltage Selection Jumper (Jp6) - Analog Devices ADSP-BF537 EZ-KIT Lite Manual

Jumper and Switch Settings
ELVIS Function Generator Configuration Switch
(SW8)
The function generator configuration switch (
necting to the left and right input signals of the audio interface. The
switch is used only when the board connects to the ELVIS station (see
"ELVIS Interface" on page
selected at a time, as described in
Table 2-13. Function Generator Configuration Switch (SW8)
Channel
AMP_LEFT_IN
AMP_RIGHT_IN
AMP_LEFT_IN
AMP_RIGHT_IN
AMP_LEFT_IN
AMP_RIGHT_IN

ELVIS Voltage Selection Jumper (JP6)

The ELVIS voltage selection jumper (
source for the EZ-KIT Lite. In a standard mode of operation, the board
receives its power from an external power supply. When
the board is powered from an ELVIS station, and no external power sup-
ply is required. The jumper setting is shown in
2-16
1-17). Each channel must have only one signal
Table
SW8 Switch Position (Default)
1 ( )
ON
2 ( )
ON
3 ( )
OFF
4 ( )
OFF
5 ( )
OFF
6 ( )
OFF
ADSP-BF537 EZ-KIT Lite Evaluation System Manual
) controls signals con-
SW8
2-13.
Audio Circuit Signal
LEFT_IN
RIGHT_IN
DAC0
DAC1
FUNCT_OUT
FUNCT_OUT
) is used to select the power
JP6
Table 2-14.
SW8
is installed,
JP6