Analog Devices ADSP-BF537 EZ-KIT Lite Manual page 25

Step 1: Connect the EZ-KIT Lite board to a personal computer (PC) run-
ning CCES using one of two options: an Analog Devices emulator or via
the debug agent.
Using an Emulator:
1. Plug one side of the USB cable into the USB connector of the emu-
lator. Plug the other side into a USB port of the PC running
CCES.
2. Attach the emulator to the header connector
the EZ-KIT Lite board.
Using the on-board Debug Agent:
1. Plug one side of the USB cable into the USB connector of the
debug agent
2. Plug the other side of the cable into a USB port of the PC running
CCES.
Step 2: Attach the provided cord and appropriate plug to the 7V power
adaptor.
1. Plug the jack-end of the power adaptor into the power connector
(labeled
J7
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
board.
3. Power the emulator (if used). Plug the jack-end of the assembled
power adaptor into the emulator and plug the other side of the
power adaptor into a power outlet. The enable/power is lit green
when power is applied.
ADSP-BF537 EZ-KIT Lite Evaluation System Manual
Using the ADSP-BF537 EZ-KIT Lite
.
ZJ1
) on the EZ-KIT Lite board.
7.5V
) is lit green when power is applied to the
LED7
(labeled ) on
ZP4 JTAG
1-5