Mercedes-Benz 963 2022 Series Manual page 71

Removing the drive shafts of the planetary hub
reduction axle
When removing, note the installation sequence of the
shims.
• Pull ignition key out of key slot.
• Lock the differential with a bolt.
• Unscrew drain screw from planetary hub reduction axles.
• Collect escaping oil in a suitable container.
• Remove end cover (3) of planetary hub reduction axle.
• Remove circlips (1) with pliers.
• Remove both drive shafts together with sun gear.
To do so, use special tool (2) or an M8 screw 120 mm long.
• Detach sun gear from drive shaft and reinstall.
• Attach end covers (3).
Filling the planetary hub reduction axle with oil
i
Add oil to planetary hub reduction drive if towing
distance exceeds 100 km.
• Unscrew oil filler screw from center of end cover (3).
• Screw oil filler can (4) into end cover (3).
• Add oil (3.25 L on each side of wheel) to planetary hub reduction drive.
Only use clean transmission oil.
• Unscrew oil replenishment tank (4).
• Screw in and tighten oil filler screw.
You can find information on approved operating fluids at every Mercedes-
Benz service center or online at:
http://bevo.mercedes-benz.com/bevolisten/bevo-blaetter-sort1.html
Actros, Antos and Arocs | Towing and recovery
Drive shaft removal
W35.30-A023-71
W35.30-A025-71
W35.10-A030-71
69