Electrohydraulic cab tilt system
Tilt driver's cab forward
•
Observe the instructions before tilting the cab.
•
Press the Tilt button at the top. The indicator lamp on the Tilt button
lights up.
The cab tilt system is switched on.
Depending on the equipment installed, the cab can be tilted forwards using
the remote control under the maintenance flap or with the button on the cab
tilt pump.
Tilting the cab forward with the remote control (1)
L cab (Actros)
•
Open maintenance flap.
•
Remove remote control (1) from holder and walk
away from swivel range of cab.
•
Press and hold the Tilt button on the remote control
(1) until the cab is tilted to the forward end position.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Tilt cab back into driving position
•
Press and hold the Tilt button on the remote control
(1) until the cab is tilted back to the rear end position
and locks in place audibly.
The cab locks automatically.
•
Place remote control in holder.
•
Close maintenance flap, see Chapter "Maintenance
flap."
•
In the bottom of the cab, push the Tilt button.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Tilting the cab forwards with the button on the cab
tilt pump
30
When the pump noise starts to get louder, the cab is
at the forward end position.
The indicator lamp on the Tilt button goes out.
•
Check that the Cab tilt lock not locked indicator
lamp in the instrument cluster goes out after the
engine start.
If the Cab tilt lock not locked indicator lamp goes
out, the cab is locked. If the Cab tilt lock not locked
indicator lamp does not go out, repeat the process
and tilt back the cab again.
Actros, Antos and Arocs | Towing and recovery
W54.25-A070-71
W60.80-A007-71