W00.01-A001-71
•
Swing flap on right of entryway steps upwards.
•
Check swivel direction of valve lever on information
label at entrance.
•
Move valve lever on tilt pump in cab-to tilt position
(2).
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Tilting the cab back to the driving position with the
button on the cab tilt pump
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
•
Move valve lever on tilt pump in cab to drive position
(1).
•
Press and hold the button (3) until the cab is tilted
back to the rear end position. The cab locks
automatically.
•
Swing down flap on right at entryway steps so that it
clicks into place.
•
In the bottom of the cab, push the Tilt button. The
indicator lamp on the Tilt button goes out.
Actros, Antos and Arocs | Towing and recovery
Information label at entrance
Cab tilt pump on right of
entryway steps
•
Press and hold the button (3) until the cab is tilted to
the forward end position. When the pump noise starts
to get louder, the cab is at the forward end position.
•
Check that the Cab tilt lock not locked indicator
lamp in the instrument cluster goes out after the
engine start. If the Cab tilt lock not locked indicator
lamp goes out, the cab is locked. If the Cab tilt lock
not locked indicator lamp does not go out, repeat the
process and tilt back the cab again.
Electrohydraulic cab tilt system
W60.80-A012-71
31