Step 2: Select The Exposure - AGFA DX-D 400 User Manual

Hide thumbs Also See for DX-D 400:
Table of Contents

Advertisement

58 | DX-D 400 | Getting started

Step 2: select the exposure

In the operator room at the NX workstation:
1. Select the thumbnail for the exposure in the Image Overview pane of the
Examination window.
On configurations with integration of X-ray exposure parameters, the
default X-Ray exposure parameters for the selected exposure are sent to
the modality and displayed on the software console.
2. Select the subexposure if more than one image is required for the same
cassette.
If an image thumbnail is configured for multiple exposures on a single
cassette, another set of thumbnails is shown in the image detail pane. Now
you have to select one of these thumbnails to send the proper default X-
Ray exposure parameters to the modality for each exposure.
0230D EN 20191209 1135
RAD Table DR with cassette in the DR bucky
RAD Wall Stand DR with cassette in the DR bucky
Free exposure using a cassette
Note: For a bucky exposure, only cassette size 43x35 is
supported.
Note: When working in a PACS environment, the preferred
workflow is to have only one image per cassette. This is needed
for optimal use of hanging protocols. However, in particular
cases (e.g. printing sites) it is supported to make more than one
exposure per cassette.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5420/1005420/101

Table of Contents