Missing Line Measurement - Leica TS01 User Manual

Cylindrical offset
measurements step-
by-step
7.5
Description
Radial method
Access
56
Field Option
Hz: Display only
E : Display only
N : Display only
Z : Display only
Radius: Display only
1. Align to a point on the cylinder.
Rotate the instrument to aim in the direction of the centre point of
the cylindrical object, such that horizontal angle is zero.
2. Press Meas for survey.
3. To repeat the measurement, press Meas again.
Press OK to save the point.
4. Using the vertica lhair, aim at the left side of the object.
5. Press OK for survey.
6. Using the verticalhair, aim at the right side of the object.
7. Press OK for survey.
8. Check the results.
9. Press Store to record the results.
Press END to exit the app without storing the results.

Missing Line Measurement

Miss.Line Measure(MLM) is an app used to compute slope distance, hori-
zontal distance, height difference and azimuth of two target points which are
either measured, selected from the memory, or entered using the keypad.
3
2
1
P1
P0 d1
TSOX_047
1. Select Apps from the Main Menu.
Description
Horizontal angle to the measured point or
calculated offset point.
Measured horizontal direction to the right
side of the object.
Measured horizontal direction to the left
side of the object.
Easting coordinate of the centre point.
Northing coordinate of the centre point.
Height of the point measured with the
reflector.
☞
This is not the calculated height of
the centre point.
Radius of the cylinder.
P0
P1-P4 Target points
d1
P2
d2
d2
d3
P3
a1
d3
a2
P4 a3
Instrument station
Distance from P1-P2
Distance from P1-P3
Distance from P1-P4
Azimuth from P1-P4
Azimuth from P1-P3
Azimuth from P1-P2
Apps