Leica TS01 User Manual page 28

Setup step-by-step
Level up with the
electronic level step-
by-step
28
3
2
1
1
1
0022418_001
1. Extend the tripod legs to allow for a comfortable working posture.
Position the tripod over the marked ground point, centring it as best
as possible.
2. Fasten the tribrach and instrument onto the tripod.
3. Turn on the instrument, and, if tilt correction is set to ON, the
laser plummet will be activated automatically, and the Auto-Com-
pensator screen appears. Otherwise, press the
any app and select Level.
4. Move the tripod legs and use the tribrach footscrews (a) to centre
the plummet over the ground point (c).
5. Adjust the tripod legs to level the axis level (c).
6. By using the electronic level, turn the tribrach footscrews to pre-
cisely level the instrument. Refer to
level step-by-step.
7. Centre the instrument precisely over the ground point by shifting
the tribrach on the tripod plate.
8. Repeat steps
The electronic level can be used to precisely level up the instrument using the
footscrews of the tribrach.
1. Turn the instrument until it is parallel to two footscrews.
2. Centre the circular level approximately by turning the footscrews of
the tribrach.
3. Turn on the instrument, and, if tilt correction is set to on, the
laser plummet will be activated automatically, and the Auto-Com-
pensator screen appears. Otherwise, press the
any app and select Level.
☞
The bubble of the electronic level and the arrows for the
rotating direction of the footscrews only appear if the
instrument tilt is inside a certain levelling range.
4. Centre the electronic level of the first axis by turning the two
footscrews. The first axis is levelled, when the bubble is exactly in
the centre of the first axis.
5. Turn the instrument by 90° so that it is perpendicular to the previ-
ous position.
c
4/6
a
5
b
Level up with the electronic
6. and 7. until the required accuracy is achieved.
7
5
5
key from within
key from within
Operation