Reset To Factory Trim By Hht; Reset To Factory Trimming By Pc; Software Write Protect; Software Write Protect By Digital Lcd Integral Display - ABB 364G Series Manual

364Ax-Gx Instruction Manual

Reset to Factory trim by HHT

Reset to Factory trim (Sensor and Output trim) by Hand Held Terminal is available. Please refer to the device
manual for the right operations.

Reset to Factory trimming by PC

Reset to Factory trim (Sens or and Output trim) by PC is available using dedicated Software. ABB c an
provide the references and the Software. Please refer to the Software instructions for the right operations.

Software Write Protect

Changes can be p revented to the tran smitter configuration data with the Soft ware write protection. If th e
transmitter Sofware write protection is activated the transmitter will not ac cept any writes to its memory.
Configuration changes, such as trim and reranging cannot take place.

Software Write Protect by Digital LCD Integral Display

Navigate the Digital LCD Integral Display menu, select Device Config >
SW Write Protect.
To change the status of the Software write p rotection select Edit then Unlock and OK to remove the
protection or Lock and OK to insert the protection.
Digital LCD Integral Display Keys sequence to Software Write Protect: 2 – 7 – Edit

Software Write Protect by HHT

Software write protection by Hand Hel d Terminal is available. Please refe r to the device manual for t he
appropriate operations.

Software Write Protect by PC

Software write protection by PC is available using dedicated Software. ABB can provide the references and
the Software. Please refer to the Software instructions for the appropriate operations.

HART Multidrop mode

The transmitter can work in the HART Multidrop mode with other transmitters on the same line. HHT and PC,
using the dedicated Software (ABB c an supply the references and the Sof tware), can set this operative
mode. Please refer to the device manual and the Software instructions for the right operations.
45