Wall Mounting Instruction; Digital Lcd Integral Display Positioning; Wiring - ABB 364G Series Manual

Wall mounting
Vertical bracket

Wall mounting instruction

1. Fix the bracket
final position
2. Connect the instrument interface
using the two long screws
bolts in the package (the torque
value shall be between 10 Nm and
12 Nm)
3. Fix the Pressure transmitter
the two short screws
package (the torque value shall be 1
Nm ± 0.2 Nm)
The use of the washers as indicated in the
picture is strongly reccomended

Digital LCD Integral Display positioning

In case the optional i ntegral display meter is
installed, it is possibl e to mount the display in fo ur
different positions rotated clockwise or counter-
clockwise with 90°  s teps.
This is possible by using one of the four conn ections
located on the ba ck of t he display at a 90 ° angle
each from the other.

Wiring

HART hand-held communicator can be connected at any wiring termination point in the loop, the minimum
restistance provided must be 250 ohm. If this is less than 250 ohm, additional resistance should be added to
allow communication.
at the wall in the
and
using
in the
364Ax-Gx Instruction Manual
18