Factory -Configuration/Calibration - ABB AquaMaster4 Manual

A Q U A M A S T E R 4 | E L E C T R O M A G N E T I C F LO W M E T E R T R A N S M I T T E R | O I/ F E T4 0 0 - E N R E V. B
24
...7 Operation

Factory -configuration/calibration

AquaMaster4 flowmeters are factory-configured and
calibrated. If changes to the configuration are required, these
are made via an Android® or Windows® phone/tablet
productivity app using a local communications interface (NFC)
app for connectivity.
The NFC interface is located on the AquaMaster4 front face
where the ABB logo is (just above the LCD) or on the wall-mount
coupler (if used). The interface enables direct interaction with
AquaMaster4 locally using the ABB Velox phone/tablet
productivity app (or other compatible ABB phone/tablet
productivity apps).
IMPORTANT (NOTE)
Before attempting to exchange data, launch the Velox
phone/tablet productivity app and enable the NFC
option on your phone/tablet (configuration device).
On an Android device this is normally found in the
Settings...> menu).
The Velox phone/tablet productivity app enables:
• process values (PV); flow rate, totalizer values to be read
• logger data to be retrieved
• configuration settings to be read or changed
• diagnostic conditions to be read
• firmware updates to be download into the transmitter
Obtain and install the ABB Velox phone/tablet productivity app
from Google Playstore, Windows store or ABB portal.
The Velox phone/tablet productivity app exchanges data with
the AquaMaster4 when a configuration device is placed on the
AquaMaster4's NFC interface (or the user end of the
AquaMaster4 Passive NFC Coupler if this is connected to the
transmitter) – see Figure 36.
Each time data is captured from a transmitter a new file is
written; historical data is retained.
Move the configuration
device to align the NFC
aerial until communication is
established
On NFC interface pad
<15 mm (0.6 in.)
Figure 36 Using a configuration device to capture data via NFC