Set Post Roll Time (Led-Panel V5 And V4 Only); Set The Intensity Of The Led Array (Led-Panel V5 Only) - Image Engineering LED-Panel V5 User Manual

Modern camera systems, especially mobile phones, often take continuous photos in the
background to avoid shooting time lag and other convenient features. If the user hits the camera
release button, a buffered photo may be shown as the actual photo. However, this photo was
taken before the user hit the release button. In this case, the auto-release function is
implemented. If "LED-Panel -setAutoRelease 1," the LED-Panel releases the iQ-Trigger at the
50th LED.
<mode>
0
1

6.2.30 Set post roll time (LED-Panel V5 and V4 only)

Function
setPostRollTime
Description
The LED-Panel keeps running for a certain time after triggering the iQ-Trigger using "LED-
Panel -setPostRollTime <duration>." Value = [0 to 30000ms].
Example:
LED-Panel –setPostRollTime 2000
6.2.31 Set the Intensity of the LED-array (LED-Panel V5 only)
Function
setLedBrightness <XXX>
Description
With the function "LED-Panel.exe -setLedBrightness <XXX>," the brightness of the LED array
can be changed from 0 to 100 counts.
Parameters
XXX – LED-array brightness in steps of 1 count; can be set from 0 (OFF) to 100 (fully ON).
Example
To set brightness to 24 counts, call LED-Panel.exe - setLedBrightness 24
Image Engineering
Description
Off
On
Seite 42 von 45