WAGO 750 XTR Manual page 13

WAGO I/O System 750 XTR
750-600/040-001 End Module with Potential Group XTR
Inadequate wire cross sections can cause temperature increases!
To avoid increasing thermal risks, only use conductor cross-sections sufficient for
the required maximum load current. The conductor cross-sections specified in
the technical data refer exclusively to the mechanical connection capacity of the
clamping points.
Do not touch hot surfaces!
The surface of the housing can become hot during operation. If the device was
operated at high ambient temperatures, allow it to cool off before touching it.
Do not exceed maximum current via CAGE CLAMP
The maximum current that can flow through the CAGE CLAMP
These contacts can be damaged when the maximum is exceeded. This could
lead to the permissible operating temperature being exceeded. That's why you
should use a suitable fuse!
Do not exceed the maximum total current for I/O modules (5 VDC) via data
contacts!
The maximum permissible total current for internal system supply of the I/O
modules may not be exceeded. The permissible total current is specified in the
technical data of the head station and power supply. The data contacts for
internal system supply can be damaged and the permissible operating
temperature can be exceeded by higher values.
When configuring the system, do not exceed the permissible total current. If there
is a higher power requirement, you must use an additional supply to provide the
system voltage (5 VDC)!
Ensure proper contact with the DIN-rail!
Proper electrical contact between the DIN-rail and device is necessary to
maintain the EMC characteristics and function of the device.
Replace defective or damaged devices!
Replace defective or damaged device/module (e.g., in the event of deformed
contacts).
Important Notes
contacts!
®
® contacts is 10 A.
Manual
Version 1.0.1
13