Front Panel Configuration; Setting Numeric Values For Parameters - Rice Lake REVOLUTION Tracer AV Installation Manual

3.1.3

Front Panel Configuration

The Tracer AV can be configured using a series of menus viewed on the RD-1 display when the
setup mode. Table 3-1 summarizes the functions of each of the main menus.
Menu
DEFCAL Default
Configuration
CONFIG Configuration
FORMAT Format
CALIBR Calibration
SERIAL Serial
PROGRM Program
SETPNT Setpoint
VERS Version
The two-button numeric editor works as follows:
Press to navigate RIGHT. Press
Units
1 Level
st
Parameter
2 Level
nd
Parameter
Default value
When moving through values below the first menu, press UNITS
selections. Press ZERO
leval above.
3.1.4

Setting Numeric Values For Parameters

1. Press to immediately accept the current value and navigate to the next menu item.
Zero
2. Press to enter edit mode.
Units
The leftmost digit will flash to indicate it can be altered.
3. Press to increment to the desired value.
Zero
4. When the value is correct, press
Select a 500lb or 300lb default configuration. You can also display and edit zero calibration a/d
count value, test weight value, and span calibration a/d count value.
Configure grads, zero tracking, zero range, motion band, overload, tare function, sample rate,
and digital filtering parameters.
Set format of primary and secondary units, display rate.
Tracer AV
Calibrate . See Section 4.0 on page 23 for calibration procedures.
Configure EDP and printer serial ports.
Set power-up mode, regulatory mode, and consecutive number values.
Configure Setpoints and digital outputs.
Display installed software version number.
Table 3-1. Tracer AV Menu Summary
Button
Move DOWN/ Increment Value
Zero
Units
Table 3-2. Button Functions in Setup Mode
to drop DOWN or select from a list of values.
Zero
Value
Value
to set the parameter and move to the next parameter on the
Figure 3-2. Setup Mode Menu Navigation
to move to the next digit.
Units
Menu Function
Function
Move RIGHT/Next
Value
to view the
Tracer AV Installation Manual - Configuration
Tracer AV
1 Level
st
Parameter
2 Level
nd
Parameter
is in
11