Windows; Power Window Controls - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 65
LED Indicator Status:
No Light: Charging pad is idle or searching for a

device.
Blue Light: Device is detected and is charging.

Red Light/Flashing: Internal error, or foreign

object is detected.
NOTE:
The wireless charging pad will not work if any of

the four doors or liftgate are open, even if the
engine is running.
Using a phone case may interfere with wireless

charging.
CAUTION!
The key fob should not be placed on the
charging pad or within 6 inches (15 cm) of it.
Doing so can cause excessive heat buildup and
damage to the fob. Placing the fob in close
proximity of the charging pad blocks the fob from
being detected by the vehicle and prevents the
vehicle from starting.

WINDOWS

P W C
OWER INDOW ONTROLS
The window switches on the driver's door control
all the door windows.
Power Window Switches
The passenger door windows can also be operated
by using the single window switches on the
passenger door trim panel. The window switches
will operate only when the ignition is in the ON/
RUN position.
GETTING TO KNOW YOUR VEHICLE
To open the window part way, push the window
switch down briefly and release it when you want
the window to stop.
NOTE:
The power window switches will remain active for
up to 10 minutes after the ignition is placed in the
OFF position. Opening one of the front doors will
disable this function.
WARNING!
Never leave children unattended in a vehicle. Do
not leave the key fob in or near the vehicle or in
a location accessible to children, and do not
leave the ignition of a vehicle equipped with
Keyless Enter 'n Go™ in the ON/RUN position.
Occupants, particularly unattended children,
can become entrapped by the windows while
operating the power window switches. Such
entrapment may result in serious injury or death.
65