Jeep H6 Manual page 221

23_H6_OM_EN_IN_t.book Page 221
Locating The 2nd Row Tether Anchorages
There are tether strap anchorages
behind each rear outboard seating
position located on the back of the seat.
ISOFIX child restraint systems will be equipped
with a rigid bar on each side. Each will have a
connector to attach to the lower anchorage and a
way to tighten the connection to the anchorage.
Forward-facing child restraints and some
rear-facing child restraints may also be equipped
with a tether strap. The tether strap will have a
hook at the end to attach to the top tether
anchorage and a way to tighten the strap after it is
attached to the anchorage.
2nd Row Tether Anchorage Locations
Center Seat ISOFIX
WARNING!
This vehicle does not have center ISOFIX or

tether anchorages. This position is not
approved for any type of ISOFIX child restraint
system. Do not install a forward facing child
seat with a tether strap in the center seating
position.
Use the seat belt to install a child seat in the

center seating position.
(Continued)
SAFETY
WARNING!
Never use the same lower anchorage to attach

more than one child restraint. Please refer to
Ú page 221 for typical installation instructions.
To Install An ISOFIX Child Restraint
1. Loosen the adjusters on the lower connectors
and on the tether strap of the child seat so
that you can more easily attach the
connectors to the vehicle anchorages.
2. Place the child seat between the lower
anchorages for that seating position. If the
second row seat can be reclined, you may
recline the seat and/or raise the head restraint
(if adjustable) to get a better fit. If the rear seat
can be moved forward and rearward in the
vehicle, you may wish to move it to its
rear-most position to make room for the child
seat. You may also move the front seat forward
to allow more room for the child seat.
221