Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 96
96 GETTING TO KNOW YOUR INSTRUMENT PANEL
B S O /B
ATTERY AVER N ATTERY
M M — E
ODE ESSAGE LECTRICAL
R A — I E
EDUCTION CTIONS F QUIPPED
This vehicle is equipped with an Intelligent Battery
Sensor (IBS) to perform additional monitoring of
the electrical system and status of the vehicle
battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions will
take place to extend the driving time and distance
of the vehicle. This is done by reducing power to or
turning off non-essential electrical loads.
Load reduction is only active when the engine is
running. It will display a message if there is a risk
of battery depletion to the point where the vehicle
may stall due to lack of electrical supply, or will not
restart after the current drive cycle.
When load reduction is activated, the message
"Battery Saver On" or "Battery Saver Mode" will
appear in the instrument cluster display.
S
These messages indicate the vehicle battery has a
AVER
low state of charge and continues to lose electrical
L
OAD
charge at a rate that the charging system cannot
sustain.
NOTE:
The charging system is independent from load

reduction. The charging system performs a diag-
nostic on the charging system continuously.
If the Battery Charge Warning Light is on it may

indicate a problem with the charging system
Ú page 98.
The electrical loads that may be switched off (if
equipped), and vehicle functions which can be
effected by load reduction:
Heated Seat/Vented Seats/Heated Wheel

Heated/Cooled Cup Holders — If Equipped

Rear Defroster And Heated Mirrors

HVAC System

150W Power Inverter System

Audio and Telematics System

Loss of the battery charge may indicate one or
more of the following conditions:
The charging system cannot deliver enough

electrical power to the vehicle system because
the electrical loads are larger than the capability
of charging system. The charging system is still
functioning properly.
Turning on all possible vehicle electrical loads

(e.g. HVAC to max settings, exterior and interior
lights, overloaded power outlets +12 Volts,
150W, USB ports) during certain driving condi-
tions (city driving, towing, frequent stopping).
Installing options like additional lights, upfitter

electrical accessories, audio systems, alarms
and similar devices.
Unusual driving cycles (short trips separated by

long parking periods).
The vehicle was parked for an extended period

of time (weeks, months).
The battery was recently replaced and was not

charged completely.