Zoom View - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 146
146 STARTING AND OPERATING
Deactivation
The system can be deactivated under the following
conditions:
The speed of the vehicle is greater than 8 mph

(13 km/h).
The vehicle is shifted into PARK.

The vehicle is in any gear other than REVERSE

and the X button is pressed.
The camera delay system is turned off manually

through the Uconnect Settings menu
Ú page 157.
NOTE:
If snow, ice, mud, or any foreign substance

builds up on the camera lenses, clean the
lenses, rinse with water, and dry with a soft
cloth. Do not cover the lenses.
If a malfunction with the system has occurred,

see an authorized dealer.
WARNING!
Drivers must be careful when backing up even
when using the Surround View Camera. Always
check carefully behind your vehicle, and be sure
to check for pedestrians, animals, other
vehicles, obstructions, or blind spots before
backing up. You are responsible for the safety of
your surroundings and must continue to pay
attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
To avoid vehicle damage, Surround View

should only be used as a parking aid. The
Surround View camera is unable to view every
obstacle or object in your drive path.
To avoid vehicle damage, the vehicle must be

driven slowly when using Surround View to be
able to stop in time when an obstacle is seen.
It is recommended that the driver look
frequently over his/her shoulder when using
Surround View.
Z V
OOM IEW
When the Rear View Camera image is being
displayed, and the vehicle speed is below 8 mph
(13 km/h) while in any gear selector position,
Zoom View is available.
By pressing the "magnifying glass" icon
in the upper left of the display screen, the
image will zoom in to four times the
standard view.
Pressing the icon a second time will
return the view to the standard Back Up
Camera display.
When the Back Up Camera View is activated, the
default view is the standard Back Up Camera view,
while in any gear. When Zoom View is selected
while the vehicle is in REVERSE, then shifted to
DRIVE or NEUTRAL, the camera will display the
standard Back Up Camera view. If the vehicle is
then returned to REVERSE gear from DRIVE or
NEUTRAL, the Zoom View selection will
automatically resume.