Jeep H6 Manual page 58

23_H6_OM_EN_IN_t.book Page 58
58 GETTING TO KNOW YOUR VEHICLE
Driver And Passenger Temperature
Control Buttons
These buttons provide the driver and passenger
with independent temperature control.
Push the red button on the faceplate or
touchscreen or press and slide the
temperature bar towards the red arrow
button on the touchscreen for warmer
temperature settings.
Push the blue button on the faceplate or
touchscreen or press and slide the
temperature bar towards the blue arrow
button on the touchscreen for cooler
temperature settings.
Sync Button
Press the Sync button on the
touchscreen to toggle the Sync feature
on/off. The Sync indicator is illuminated
when Sync is on. Sync is used to
synchronize the passenger temperature setting
with the driver temperature setting. Changing the
passenger temperature setting while in Sync will
automatically exit this feature.
NOTE:
The Sync button is only available on the touch-
screen.
Blower Control
Blower Control is used to regulate the
amount of air forced through the Climate
Control system. There are seven blower
speeds available. Adjusting the blower
will cause automatic mode to switch to manual
operation. The speeds can be selected using either
the blower control knob on the faceplate or the
buttons on the touchscreen.
Faceplate
The blower speed increases as you turn the blower
control knob clockwise from the lowest blower
setting. The blower speed decreases as you turn
the blower control knob counterclockwise.
Touchscreen
Use the small blower icon to reduce the blower
speed and the large blower icon to increase the
blower speed. Blower can also be selected by
pressing the blower bar area between the icons.
Mode Control
Mode Control regulates the airflow
distribution. The airflow distribution can
be adjusted so air comes from the
instrument panel outlets, floor outlets,
defrost outlets, and demist outlets.
Faceplate
Push the Mode button to changes the airflow
distribution mode.
Touchscreen
Press one of the "MODE" buttons to change the
airflow distribution mode.
Panel Mode
Air comes from the outlets in the
instrument panel. Each of these outlets
can be individually adjusted to direct the
flow of air. The air vanes of the center
outlets and outboard outlets can be moved up and
down or side to side to regulate airflow direction.
There is a shut-off wheel located below the air
vanes to shut off or adjust the amount of airflow
from these outlets.