Activation - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 134
134 STARTING AND OPERATING
NOTE:
The Active Speed Limiter can be set with the
vehicle stationary or in motion.
Set the Active Speed Limiter to standby by pressing
the setting button on the steering wheel; the Active
Speed Limiter will turn to standby and the white
indicator light will appear in the instrument cluster.
NOTE:
Cruise Control (if equipped) cannot be enabled
when Active Speed Limiter is on. If enabled, they
will be disabled when the Speed Limiter on/off
button is pushed.
A
CTIVATION
To activate the feature, push the Active Speed
Limiter button located on the right side of the
steering wheel. A message will appear along with
an indicator light in the instrument cluster display
to signal that Active Speed Limiter has been
activated.
After the Active Speed Limiter on/off button has
been pushed, you must press the SET (+) or SET (–)
button to set the target speed (or the RES (resume)
button when there is already a previously set target).
Push the SET (+) or SET (–) button to raise and
lower the target speed to the desired value.
Pushing and holding down the SET (+) or SET (–)
button will increase/decrease the speed value by
increments of 5 mph (5 km/h).
Each time the Active Speed Limiter is activated,
pushing the RES (resume) button will set the target
speed to the last programmed value from the
previous activation.
Activate The Active Speed Limiter (When Speed
Setting Is Memorized)
When the RES (resume) button on the steering
wheel is pushed, the speed limit will be set to the
memorized speed.
NOTE:
If the memorized speed limit is lower than the
current vehicle speed, the Active Speed Limiter will
not operate even though you try to set it. In this
case, a corresponding message will be displayed in
the instrument panel.
Display During Activation
When the Active Speed Limiter is active, the set
speed limit will be displayed in the instrument
panel, and the Active Speed Limiter indicator light
will turn to green.
To Temporarily Deactivate The Active Speed
Limiter
The Active Speed Limiter may be temporarily
deactivated when the accelerator pedal is fully
pressed while driving with the Active Speed Limiter
activated. In this case, the corresponding message
will be displayed in the instrument panel.
To Change The Speed Limit
Press the SET+ or SET- button on the steering
wheel while the Active Speed Limiter is active. If
the SET+ or SET- button is pressed and held down,
the speed limit will change in the increments by
1 mph (1 km/h).
Return The Active Speed Limiter To Standby
If you press the CANC button on the steering wheel
while the Active Speed Limiter is active, the Active
Speed Limiter will be deactivated and return to
standby. The speed limit display on the instrument
panel will turn white with a strikeout line through
the set speed value, but the set speed will still be
memorized.