Jeep H6 Manual page 213

23_H6_OM_EN_IN_t.book Page 213
Customer Action
NOTE:
Each step MUST BE held for at least two seconds
6. Place turn signal in neutral state.
7. Turn right turn signal switch ON.
8. Place turn signal in neutral state.
9. Turn left turn signal switch ON.
10. Turn left turn signal switch OFF. (Turn Signal Switch Must be placed in
Neutral State).
11. Turn ignition STOP/OFF/LOCK.
12. Turn ignition MAR/ON/RUN. (Entire sequence needs to be completed
within one minute or sequence will need to be repeated).
Turn hazard flashers OFF (Manually).
If a reset procedure step is not completed within 60 seconds, then the turn signal lights will blink and the reset procedure must be performed again in order to
be successful.
Customer Will See
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS.
Right turn light is ON SOLID.
Left turn light is ON SOLID.
Right turn light is OFF.
Left turn light is OFF.
System is now reset and the engine may be started.
SAFETY 213