Jeep H6 Manual page 57

23_H6_OM_EN_IN_t.book Page 57
In cold weather, use of Recirculation mode may
lead to excessive window fogging. The
Recirculation feature may be unavailable if
conditions exist that could create fogging on the
inside of the windshield.
NOTE:
After 25 minutes of continuous use, Recirculation
mode will automatically shut off for two minutes to
allow fresh air intake inside the cabin to maintain
sufficient oxygen levels.
AUTO Button
Press and release this button on the
touchscreen, or push the button on the
faceplate, to change the current setting.
The AUTO indicator illuminates when
AUTO is on. This feature automatically controls the
interior cabin temperature by adjusting distribution
and amount of airflow. Air Conditioning (A/C) may
be active during AUTO operation to improve
performance. Toggling this function will cause the
system to switch between manual override and
automatic modes Ú page 60.
MAX Defrost Button
Push the MAX Defrost button to change
the current airflow setting to Defrost
mode. The indicator illuminates when
this feature is on. Performing this
function will cause the automatic climate controls
to change to manual mode. The blower speed
increases to full (all LEDs on) when MAX Defrost
mode is selected, the air conditioning compressor
is turned on (LED on), both driver and passenger
temperature controls are set to HI, Defrost mode is
selected (LED on), rear defroster is turned on (LED
on) and the air recirculation is turned off (LED off).
If MAX Defrost mode is turned off, the Climate
Control system will return to the previous setting.
Rear Defrost Button
Press and release the button on the
touchscreen, or push and release the
button on the faceplate, to turn on the
rear window defroster and the heated
outside mirrors (if equipped). The Rear Defrost
indicator illuminates when the rear window
defroster is on. The rear window defroster
automatically turns off after 10 minutes.
GETTING TO KNOW YOUR VEHICLE
NOTE:
If the rear defrost is turned on again after the first
time-out, it will be enabled for 5 minutes and then
automatically turn off.
CAUTION!
Failure to follow these cautions can cause
damage to the heating elements:
Use care when washing the inside of the rear

window. Do not use abrasive window cleaners
on the interior surface of the window. Use a
soft cloth and a mild washing solution, wiping
parallel to the heating elements. Labels can
be peeled off after soaking with warm water.
Do not use scrapers, sharp instruments, or

abrasive window cleaners on the interior
surface of the window.
Keep all objects a safe distance from the

window.
57