Operate The Setup Menu Of The Camera - Panasonic WJ-HD616K Operating Instructions Manual

Operate the setup menu of the camera

To control the camera connected to the recorder, it is necessary in advance to configure the settings of the
camera function. The settings of the camera function can be configured on the setup menu of the camera.
It is possible to call the setup menu of the camera from the "Sub Menu". The contents of the setup menu and
the operation procedures vary depending on the model of the camera. Refer to the operating instructions of the
camera for further information.
The following are descriptions of how to display the setup menu of the camera and of how to perform the basic
operation.
Step 1
Press the [SUB MENU] button.
→ The "Sub Menu" window will be displayed.
Step 2
Move the cursor onto the [Camera control] button of
the "Sub Menu", and then press the [SET] button.
→ The menu list will be displayed. Move the cursor
onto "Camera menu" on the displayed menu list,
and then press the [SET] button.
→ The "Camera menu" menu will be displayed and
the camera setup menu will be displayed on the
monitor.
Note:
• The status bar will be hidden while the camera
menu panel is being displayed.
70
Step 3
Operate the setup menu of the camera using the
"Camera menu" panel.
To operate the setup menu of the camera, use the fol-
lowing buttons.
Move the cursor
Change parameters
Apply the set value or
move to the lower level
menu
Move to the higher level
menu
Display the special
menu
Reset the camera
Step 4
To close the setup menu of the camera, press the
camera selection button [4].
Note:
• When the camera has the refresh function
(REFRESH), it is possible to execute the refresh
function by selecting the [2] button on the
"Camera menu" panel.
• The "Camera menu" panel may sometimes remain
displayed after the setup menu of the camera is
closed such as when resetting the camera, etc. In
this case, select the [4] button on the camera
menu panel.
• Only users whose user level is allowed to control
cameras or to configure the settings can configure
the settings of the camera.
Arrows button (CDA B)
Arrows button (A B)
[SET] button
[SETUP/ESC] button
Move the cursor onto
"SPECIAL" on the setup
menu of the camera, and
then press the camera
selection button [2].
Move the cursor onto
"CAMERA RESET" on the
setup menu of the camera,
and then press the camera
selection button [3].