Table of Contents
Advertisement
Controls and indicators
PRIMARY / SECONDARY
Switches the pump between Primary and Secondary infusion modes (if enabled).
ON / OFF
Switches the pump on and off.
PRIME / BOLUS
Primes the IV infusion set.
Administers bolus during the infusion.
CLEAR / SILENCE ALARM
Resets numeric values to zero.
Silences alarms and warnings for 1 minute.
ENTER
Scrolls between rate, time, VTBI and total volume infused (VI).
Enters values for selected infusion/configuration parameters.
Confirms the rate during an infusion titration.
RUN / HOLD
Starts and stops the infusion.
Cancels alarm.
CHEVRONS
Increases or decreases the infusion rate, TIME limit and VTBI.
Press and hold to increase the selection speed.
Used to adjust user selectable options.
When any of the following are illuminated:
AC POWER INDICATOR - The pump is connected to an AC power supply.
RATE
The pump is displaying the infusion rate in millilitres per hour (ml/h).
VTBI
The pump is displaying the Volume To Be Infused (VTBI) in millilitres (ml).
VI
The pump is displaying the Volume Infused (VI) in millilitres (ml).
TIME
The pump is displaying the infusion time in hours : mins.
MICRO
The pump is operating in the MICRO mode. When not illuminated, the pump is in the STANDARD
mode.
SEC
The pump is operating in the SECONDARY mode. When not illuminated, the pump is in the PRIMARY
mode.
ml/hr
(Millilitres / hour) When ml is illuminated the pump displays the VTBI or VI. When the hr is illuminated
the pump displays the rate or infusion time.
Infusion indicator - Infusing in STANDARD mode.
Infusion indicator - Infusing in MICRO mode.
Infusion indicator - Displays fluid drops detected by the flow sensor when infusing in STANDARD mode.
Infusion indicator - Displays fluid drops detected by the flow sensor when infusing in MICRO mode.
Alaris® GW Volumetric Pump
Introduction & Start up
7/77
1000SM00006 Issue 4
Advertisement
Chapters
Table of Contents
