Table of Contents
Advertisement
Setup
Connecting the
printer to a local
port of a PC
64
CAUTION:
•
Always use a shielded interface cable. Use of an unshielded cable can
result in radio interference with data.
NOTE:
•
Printing through a serial port (LocalTalk) is not supported on Macintosh
computers.
Using a parallel interface cable
If you do not have a parallel interface cable, you will need to purchase one
from your local computer store or dealer
interface" on page
1
Make sure the computer, printer and the other
connected peripheral devices are turned off.
2
Connect the Centronics Type C parallel interface cable
to the computer's parallel connector and the printer's
parallel interface connector.
Computer's parallel
connector
NOTES:
•
The actual connector on the computer may differ depending on
the manufacturer of the computer.
•
If the cable is connected to the PC via a printer buffer or switch,
the printer may not print.
3
Connect the power cord to the printer's AC inlet and to
an AC outlet.
Power cord
AC outlet
296).
Centronics Type C parallel cable
(see "Bidirectional parallel
Parallel interface
connector
Advertisement
Table of Contents
