Table of Contents
Advertisement
Message
Flash
Device Failure
Flash File
Operation Failed
Front or Right door
Open
Fuser Unit
Not installed
Fuser Unit
wearing out*
Fuser Unit
Worn out
Imaging Unit
No tension
Imaging Unit
Not installed
Imaging Unit
wearing out
Imaging Unit
Worn out
Initializing
Insert printed pages in
MP tray, press Continue
Insufficient
Memory
Jam at A
See front door label
Jam at B
See front door label
* Printing a large quantity of pages with high coverage will result in the
message "Fuser Unit wearing out" to be displayed earlier than its expected
life. In this case, replace the fuser unit.
Care and Maintenance
Corrective Action/Additional Information
Flash DIMM hardware error. Cycle Power. If
printer does not function normally, call for
service.
Flash DIMM is functioning abnormally. Cycle
Power. If printer does not function normally,
call for service.
Close Front or Right door.
Install a Panasonic fuser unit.
Fuser unit will need to be replaced soon.
Replace the fuser unit.
Set the upper lever of the color imaging unit
to "Lock".
Install color imaging unit.
Color imaging unit will need to be replaced
soon.
Replace the color imaging unit.
Printer is initializing.
Insert printed pages into multi-purpose (MP)
tray, then press the
Not enough memory to finish printing.
Change printing resolution to 600 x 600 dpi if
you selected higher resolution.
or
Install additional memory in the printer.
Clear paper jam. See printer's front door
label.
(See page
221.)
Clear paper jam. See printer's front door
label.
(See page
223.)
/CONTINUE button.
249
Advertisement
Table of Contents
