Panasonic KX-PS8100 Operating Instructions Manual page 161

Panansonic operating instructions digital color imaging system kx-ps8100
Table of Contents

Advertisement

Setup from the Printer Panel and WebSetup
Subnet Mask— If you need to set the subnet mask, enter one of the
following values:
255.0.0.0 if the IP address starts with a number less than 128
255.255.0.0 if the IP address starts with a number from 128 through 191
255.255.255.0 if the IP address starts with a number greater than 191
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from
those listed.
Enable on Token Ring—Enable this option if you have a TCP/IP network
connected to the printer over Token Ring. If you use Token Ring, enabling
TCP/IP for Token Ring is required for enabling the Fiery WebTools.
IP Address—Enter KX-PS8100 IP address for Token Ring. The printer is
shipped with the IP address set to the loopback address, (127.0.0.1) which
is an internal address used for network checking. If you plan to print with
TCP/IP, you must first assign the printer a unique network IP address. For
information about setting up printing with TCP/IP,
Printer to a Network" on page
Subnet Mask—If you need to set the subnet mask, enter one of the
following values:
255.0.0.0 if the IP address starts with a number less than 128
255.255.0.0 if the IP address starts with a number from 128 through 191
255.255.255.0 if the IP address starts with a number greater than 191
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from
those listed.
Gateway—If your TCP/IP network has a gateway, and users outside the
gateway plan to print to the printer using TCP/IP, enter the gateway address
here. By default, the loopback address, 127.0.0.1, is set. Obtain the correct
gateway address from your network administrator.
Enable AppleTalk—Enable this option if you have an AppleTalk network
connected to the printer. This setting enables the printer to communicate
over AppleTalk networks.
see "Connecting the
70.
161

Advertisement

Table of Contents
loading

Table of Contents